X-Star WiFi WhiteX-Star Remote Controller White

To calibrate your X-Star remote controller

Step 1 
Open the Starlink app and tap Start.

Starlink App Landing Page

Step 2 
Tap the small RC transmitter symbol located near the status bar.

Starlink App First Person View Remote Controller Settings

Step 3 
Tap RC Calibration. 

TAP RC Calibration - Starlink

Step 4 
Release both command sticks and the Gimbal Pitch Dial to the central position. The three centered circles on the RC calibration screen will be highlighted successively. Tap Start to begin calibration.

Tap Start Starlink RC Calibration

Step 5 
Push both command sticks outwards in all four directions, and hold for 2 seconds in each direction.

Step 6 
Turn the Gimbal Pitch Dial clockwise and counterclockwise to its two ends and hold for 2 seconds at each end. All the bars on the screen will be fully highlighted when the calibration is completed. Tap Complete to finish.

RC Calibration Tap Complete - Starlink

SHORTCUT: You can initialize the RC calibration by pressing and holding the Power 
Remote Controller Power Button Iconand Take Off Remote Controller Take Off Button Iconbuttons for 3 seconds.

Remote Control Short Cut Power + Take Off

NOTE: If the compass calibration continuously fails, please contact our customer support department.

Back to Tutorial Articles